Step-by-Step Installation Instructions for the Euro Bracket by Euro Systems, LLC
Please read the following instructions completely before beginning. In addition to these instructions, your Euro Bracket Kit should include:
(1) Euro Bracket, Skull Mounting Bracket (skull not included)
(4) 5/8” Stainless Screws The following tools will be needed to complete this project:
• Electric/Cordless Hand Drill
• 3/32” Drill Bit
• Phillips Screw Driver Step 1 Invert the skull & position the Euro Bracket as shown in Figure 1. Note the orientation of the bracket & location of the four screw holes. Step 2 Center the rear rails support holes an equal distance left/right of the spinal cord opening & centered on the radius of the high boney spot. Step 3 While holding the bracket securely in place; drill both rear holes into the center on high boney spot left/right of spinal cord opening, approximately 1/2” deep using a 3/32” diameter drill bit. Note: use the holes in the support rails as a drill guide. Step 4 With the bracket in place, use two of the screw fasteners provided, and tighten the screws approximately 3/8 of an inch deep, one at a time into each of boney projection. Note: do not completely tighten screws at this time. Step 5 Drill the front two holes. Insert the two remaining screw fasteners & tighten. Note: the thickness of the bone where the two front screws attach is quite thin, only snug these screws. Over tightening could strip out the holes. Step 6 Finish by tightening the two remaining rear screws completely. You are now ready to proudly display your trophy. | 
Installation 
